Free Economy Shipping on orders over $89

Reduced shipping cost available on smaller orders

Tippmann Parts
Questions? Call us!
Mon-Fri - 9-5 CST
Security Verified
(Your shopping cart is empty)
Knowledge Base:  
You are here: Knowledge Base > Tippmann A5

Upgrading to an E Grip and an aftermarket Board [X7, X7 Phenom, A5 (2011)]


Last Updated: 06/13/2013
I have an X7, X7 Phenom, or an A5 (2011) with a manual trigger, and an electronics board.  What other parts do i need to make a complete grip?

Unfortunately there are a few parts needed that are not available separately from the manufacture.  And all of the internal parts, lower receiver halves, and other parts that are required are as expensive separately as in a kit.  You need to get the complete upgrade kit and swap in your board.

http://www.tippmannparts.com/Tippmann-E-Grip-X7-p/5003.htm

http://www.tippmannparts.com/Tippmann-E-Grip-H-E-A5-p/3794.htm

Was this article helpful?

Comments:
 

Related Articles
 >

Upgrade your A5 RT Hoses from 1/16" to 1/8" [A5]


 >

Converting E-grips to Mechanical [98, A5, X7, Alpha Black, Carver One, Project Salvo]


 >

Installing a Shoulder Stock - Tippmann and US Army [98, A5, X7, Phenom, Alpha Black, Carver One, Project Salvo]


 >

Are Tippmann Paintball Guns easy to maintain? [98, A5, Crossover, Gryphon, TiPX, X7, Phenom, Alpha Black, Carver One, Project Salvo]


 >

E-Grip Trigger Board Problem [98, A5, Crossover, X7, Phenom, Alpha Black, Carver One, Project Salvo]


 >

Cyclone Feed Troubleshooting [98, A5, X7, Phenom, Alpha Black, Project Salvo]


 >

Cocking / Cycling Issues [98, A5, Gryphon, X7, Alpha Black, Carver One, Project Salvo]


 >

Response Trigger Troubleshooting [98, A5, X7, Alpha Black Elite, Project Salvo]


 >

Shooting / Air System / Leak Problem Troubleshooting [X7 Phenom]


 >

Tippmann Stock A5 and X7 Valve Updates