Pro-Team Products Tac-Cap II [Cyclone Feeds] - Cle
January 29, 2013
Reviewer:
marcoacm007@hotmail.com from Miami, FL United States
This buy was perfect too. i had de cyclone feed system, and this new accesory makes my marker better. thanks.
Was this review helpful to you?
0 of 0 people found the following review helpful:
After a bit of grinding it works great.
June 6, 2012
Reviewer:
Teej from LS, IA United States
I had to grind down the outside diameter of the cyclone hopper to make it easier to remove from the cyclone feeder. I completely ground off the bump that is supposed to lock it from rotating inside the feeder, it is so tight it wont rotate anyway. Cause the plastic used is not flexible it is hard to rotate and remove. In addition to grinding the outside diameter of the hopper part that fits into the cyclone feeder I also ground the bottom down a bit after reading a review that said it rubs on the cyclone paddles. I didn't have a problem with it on the paddles but then again I have the stock paddles So with a bit of dremel grinding and sanding and plastic melting you can custom fit your hopper to your cyclone feeder. Making it as tight a fit or lose a fit as you would like, I personally like a tight fit, but not to tight so you cant pull it out All said and done (grinding and all) the hopper looks great and does hold a lot more then I figured (45) and its low profile makes it amazing
Was this review helpful to you?
0 of 0 people found the following review helpful:
Pro-Team products tac-cap review
February 22, 2012
Reviewer:
Jimbo from Doylestown, PA United States
This is a cool attachment and a good price for what it is, but the bottom lip gets in the way of the rubber paddles in the cyclone feed. I had to cut 1/8 of an inch off below the notch so the cyclone feed could function. Otherwise, it's pretty cool and makes you put more consideration into where your shots are going.