Free Economy Shipping on orders over $89

Save $30 now on any Tippmann 98, A5, or FT-12.

Reduced shipping cost available on smaller orders

Tippmann Parts
Questions? Call us!
Mon-Fri - 9-5 CST
Security Verified
(Your shopping cart is empty)
Knowledge Base:  

Air Volume Valve Spacer [Crossover]


Last Updated: 06/11/2013
For play requiring lower velocity settings, it may be necessary to utilize the Air Volume Spacer included with the Crossover.

To install:

1) Follow Unloading Your Marker on page 10 and Air/CO2 Cylinder Removal instructions on page 16 of your Crossover Manual.

2) Loosen and unscrew rear end cap and air valve assembly.

3) Snap Air Volume Valve Spacer securely onto shaft of air valve (Valve End Cap).

4) Reassemble rear end cap and air valve assembly into receiver.

5) Adjust regulator pressure to achieve desired velocity.

Was this article helpful?

Comments:
 

Related Articles
 >

Are Tippmann Paintball Guns easy to maintain? [98, A5, Crossover, Gryphon, TiPX, X7, Phenom, Alpha Black, Carver One, Project Salvo]


 >

E-Grip Trigger Board Problem [98, A5, Crossover, X7, Phenom, Alpha Black, Carver One, Project Salvo]


 >

Shooting / Air System / Leak Problem Troubleshooting [Crossover]


Built with Volusion