Are Tippmann Paintball Guns easy to maintain? [98, A5, Crossover, Gryphon, TiPX, X7, Phenom, Alpha Black, Carver One, Project Salvo] Paintball guns are basically pneumatic tools. Keeping them clean and lubricated are the most important things. Replacing the internals seals at least 1 time per year (2-3 times if you are a more |
Cocking / Cycling Issues [98, A5, Gryphon, X7, Alpha Black, Carver One, Project Salvo] Having shooting problems?
Is your gun stuttering or not re-cocking?
This is caused by excess drag on the internals of the gun, or seals leaking and not providing enough pressure to re |
Converting E-grips to Mechanical [98, A5, X7, Alpha Black, Carver One, Project Salvo] You will need these parts when converting an E-Grip to a Mechanical Semi-Auto For 98 Customs (with Push Sear, and Platinum Series) and US Army (Alpha Black, Project Salvo, Carver One): 2493 - Complet |
Cyclone Feed Troubleshooting [98, A5, X7, Phenom, Alpha Black, Project Salvo]
Cyclone troubles? Try these helpful tips
Always keep the cyclone clean. Broken paint and shell will get on the Feeder Housing , Sprocket Paddles , Feeder Axle , |
E-Grip Trigger Board Problem [98, A5, Crossover, X7, Phenom, Alpha Black, Carver One, Project Salvo] If you have a problem with an E-Grip Trigger, these steps may help to solve your issue:
Before doing and trouble shooting of any kind, make sure your marker is degassed and follow your manual for di |
Installing a Shoulder Stock - Tippmann and US Army [98, A5, X7, Phenom, Alpha Black, Carver One, Project Salvo] To assemble a stock on a 98 series gun , please follow the disassembly procedures in your gun manual . You will need to remove the End Cap and insert the stock into the slots where the End Cap was. Yo |
Response Trigger Troubleshooting [98, A5, X7, Alpha Black Elite, Project Salvo]
Response Trigger isn't getting a burst rate of fire
To Tune the RT System
Follow the air cylinder installation and velocity screw adjustment instructions in the Getting |
Tippmann Stock A5 and X7 Valve Updates The Tippmann A5's and X7's (not the Phenoms ) use almost the identical internal valve. In fact, when the X7 first came out it used the same valve as the A5. The original valve assembly used in A-5's |
Upgrade your A5 RT Hoses from 1/16" to 1/8" [A5] Easy to do. You need this 1/8" hose Response Trigger fitting kit . http://www.tippmannparts.com/Tippmann-Adapter-Cyclone-Feed-Response-Kit-98-p/2759.htm and 1 extra hose for the A5. http://www.t |
Upgrading to an E Grip and an aftermarket Board [X7, X7 Phenom, A5 (2011)] I have an X7, X7 Phenom, or an A5 (2011) with a manual trigger, and an electronics board. What other parts do i need to make a complete grip?
Unfortunately there are a few parts needed that are no |
|